AEM Electronics No-Weld O2 Oxygen Sensor Bung Mount 2.0" Genesis Offroad This harness is not vehicle

This harness is not vehicle specific and is intended for integrations where additional sensors or control outputs are required

This platform has one locking storage access door that provides access to an under-platform storage area that is approximately 9” high

PC64 / GMC / Acadia / 1st Gen (2007-2016) / (3

CB30 and CB60

The 2 & 3 ton handle is 1 3/8" diameter and does not come with a foam cover

AEM Electronics No-Weld O2 Oxygen Sensor Bung Mount 2.0" Genesis Offroad This harness is not vehicleAEM No Weld O2 Sensor Mount requires no welding at all. Installation is quick and easy. Simply drill a hole in the exhaust piping, install the gasket, and bolt on the clamp. If you need to install an oxygen sensor and welding is not available, this solution is a life saver. You can have a wideband installed in your car in minutes. NOTE: Oxygen sensor sold separately Quick and easy No welding required Gasket included Fits 1. 75" to 2. 0"